Administrator Guide

Field Description
Total DCBX
Frames received
Number of DCBX frames received from the remote peer port.
Total DCBX Frame
errors
Number of DCBX frames with errors received.
Total DCBX
Frames
unrecognized
Number of unrecognizable DCBX frames received.
Example
DellEMC# show interface tengigabitethernet 1/9 dcbx detail
E-ETS Configuration TLV enabled
e-ETS Configuration TLV disabled
R-ETS Recommendation TLV enabled
r-ETS Recommendation TLV disabled
P-PFC Configuration TLV enabled
p-PFC Configuration TLV disabled
F-Application priority for FCOE enabled
f-Application Priority for FCOE disabled
I-Application priority for iSCSI enabled
i-Application Priority for iSCSI disabled
-----------------------------------------------------------
Interface TenGigabitEthernet 1/9
Remote Mac Address 00:00:00:00:00:11
Port Role is Auto-Upstream
DCBX Operational Status is Enabled
Is Configuration Source? TRUE
Local DCBX Compatibility mode is CEE
Local DCBX Configured mode is CEE
Peer Operating version is CEE
Local DCBX TLVs Transmitted: ErPfi
Local DCBX Status
-----------------
DCBX Operational Version is 0
DCBX Max Version Supported is 0
Sequence Number: 2
Acknowledgment Number: 2
Protocol State: In-Sync
Peer DCBX Status:
----------------
DCBX Operational Version is 0
DCBX Max Version Supported is 255
Sequence Number: 2
Acknowledgment Number: 2
Total DCBX Frames transmitted 27
Total DCBX Frames received 6
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on Ethernet ports that support
converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
Syntax
dcb-map map-nameTo remove a DCB map from an ethernet interface, use the no dcb-map command.
Parameters
map-name Enter a DCB map name. The maximum number of alphanumeric characters is 32.
Defaults None.
500 Data Center Bridging (DCB)