Service Manual

and other paths do not have any weight configured, then regular ECMP is used for
forwarding.
You can specify the weight value only to destination address and not on the egress
port.
A route is considered for weighted ECMP calculations only if each paths corresponding
to that route is configured with a weight.
You cannot use the VRF attribute of this command to configure routes in a
management VRF. When a specific VRF is deleted, all the configured static routes
corresponding to that VRF are automatically removed.
Example
Dell(conf)# ip route 1.1.1.0/24 4.4.4.2 weight 100
Dell(conf)# ip route 1.1.1.0/24 6.6.6.2 weight 200
Dell(conf)# do show running-config | grep route ip route
1.1.1.0/24 4.4.4.2 weight 100 ip route 1.1.1.0/24 6.6.6.2 weight
200
Dell(conf)# ip route vrf test 1.1.1.0/24 4.4.4.2 weight 100
Dell(conf)# ip route vrf test 1.1.1.0/24 6.6.6.2 weight 200
Dell(conf)#
Dell(conf)# do show running-config | grep route ip route vrf
test 1.1.1.0/24 4.4.4.2 weight 100 ip route vrf test 1.1.1.0/24
6.6.6.2 weight 200
Related
Commands
• show ip route — view the switch routing table.
ip source-route
Enable Dell Networking OS to forward IP packets with source route information in the header.
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source
command.
Defaults Enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
IPv4 Routing 992