Service Manual

Version Description
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related
Commands
• show ip interface — display the interface routing status and configuration.
ip route
Assign a static route to the switch.
Syntax
ip route [vrf vrf-name] ip-address mask {ip-address | interface
[ip-address]} [distance] [permanent] [tag tag-value] [vrf vrf-
name] [weight weight-value]
To delete a specific static route, use the no ip route destination mask
command.
To delete all routes matching a certain route, use the no ip route destination
mask command.
Parameters
vrf vrf-name (Optoinal) Enter the keyword vrf and then the name of the VRF
to configure a static route corresponding to that VRF. Use this
VRF option after the ip route keyword to configure a static
route on that particular VRF.
destination Enter the IP address in dotted decimal format of the destination
device.
mask Enter the mask in the slash prefix format (/x) of the destination IP
address.
ip-address Enter the IP address of the forwarding router in dotted decimal
format.
interface Enter one of the following keyword followed by the interface
information
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
IPv4 Routing 989