Service Manual

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information
To fully enable DNS, also specify one or more domain name servers with the ip name-
server command.
Dell Networking OS does not support sending DNS queries over a VLAN. DNS queries
are sent out all other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
Commands
• ip name-server — specify a DNS server.
• show hosts — view the current bindings.
ip domain-name
Configure one domain name for the switch.
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name Enter one domain name to be used to complete unqualified
names (that is, incomplete domain names that cannot be
resolved).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
IPv4 Routing 975