Service Manual

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series. Modified to display the LAG failover
group status.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information The following describes the show interfaces port-channel command shown in
the following example.
Field Description
Port-Channel 1... Displays the LAG’s status. In the Example, the status of the LAG’s
LAG fate-sharing group (“Failover-group”) is listed.
Hardware is... Displays the interface’s hardware information and its assigned
MAC address.
Port-channel is
part...
Indicates whether the LAG is part of a LAG fate-sharing group
(“Failover-group”).
Internet address... States whether an IP address is assigned to the interface. If an IP
address is assigned, that address is displayed.
MTU 1554... Displays link and IP MTU.
LineSpeed Displays the interface’s line speed. For a port channel interface,
it is the line speed of the interfaces in the port channel.
Members in this... Displays the interfaces belonging to this port channel.
ARP type:... Displays the ARP type and the ARP timeout value for the
interface.
Last clearing... Displays the time when the show interfaces counters were
cleared.
Queueing
strategy.
States the packet queuing strategy. FIFO means first in first out.
packets input... Displays the number of packets and bytes into the interface.
Input 0 IP
packets...
Displays the number of packets with IP headers, VLAN tagged
headers, and MPLS headers. The number of packets may not
add correctly because a VLAN tagged IP packet counts as both a
VLAN packet and an IP packet.
0 64-byte... Displays the size of packets and the number of those packets
entering that interface. This information is displayed over two
lines.
Interfaces 927