Service Manual

NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a copper
SFP2 module with catalog number GP-SFP2-1T in the S25P model of the S-
Series, you can manually set its speed with the speed command. When you set
the speed to 10 or 100 Mbps, you can also use the duplex command.
If you use an active optical cable (AOC), you can convert the QSFP+ port to a 10
Gigabit SFP+ port or 1 Gigabit SFP port. Use the speed command to enable the
required speed.
Related
Commands
• duplex (10/100 Interfaces) — configures duplex mode on physical interfaces.
• negotiation auto — enable or disable auto-negotiation on an interface.
speed (Management interface)
Set the speed for the Management interface.
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 100 Mb/s.
1000 Enter the keyword 1000 to set the interface’s speed to 1000
Mb/s.
auto Enter the keyword auto to set the interface to auto-negotiate
its speed.
Defaults auto
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Interfaces 908