Service Manual

show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode
interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the
interface information:
• For a port channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a backup interface for this interface, enter the keyword
backup.
NOTE: This command also enables you to view
information corresponding to a range of ports.
• For physical interfaces, you can specify multiple ports as
slot/port-range. For example, if you want to display
information corresponding to all ports between 1 and 4,
specify the port range as show interfaces
interface-type 1/1 - 4.
• For port–channel interfaces, you can specify multiple ports
as port-range. For example, if you want to display
information corresponding to all ports between 1 and 4,
specify the port range as show interfaces port—
channel 1 - 4
.
stack-unit unit-id (OPTIONAL) Enter the keywords stack-unit then the stack
member number.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Added support to display the interface configurations
corresponding to a range of ports.
Interfaces 894