Service Manual

Example
Dell(conf)# interface tengigabitethernet 1/1
Dell(conf-if-te-1/1)# portmode hybrid
Dell(conf-if-te-1/1)# interface vlan 10
Dell(conf-if-vl-10)# untagged tengigabitethernet 1/1
Dell(conf-if-vl-10)# interface vlan 20
Dell(conf-if-vl-20)# tagged tengigabitethernet 1/1
Dell(conf-if-vl-20)#
Example
Dell(conf-if-vl-20)# do show interfaces switchport
Name: TenGigabitEthernet 1/1
802.1QTagged: Hybrid
Vlan membership:
Vlan 10, Vlan 20
Native VlanId: 10
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)# interface vlan 10
Dell(conf-if-vl-10)# no untagged tengigabitethernet 1/1
Dell(conf-if-vl-10)# interface vlan 20
Dell(conf-if-vl-20)# no tagged tengigabitethernet 1/1
Dell(conf-if-vl-20)# interface tengigabitethernet 1/1
Dell(conf-if-te-1/1)# no portmode hybrid
Dell(conf-if-vl-20)#
rate-interval
Configure the traffic sampling interval on the selected interface.
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect traffic data.
The range is from 5 to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the
number of seconds designated here rounds to the
multiple of 15 seconds lower than the entered value. For
example, if 44 seconds is designated, it rounds to 30; 45
to 59 seconds rounds to 45.
Defaults 299 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Interfaces 874