Service Manual

interface range
This command permits configuration of a range of interfaces to which subsequent commands are applied
(bulk configuration). Using the interface range command, you can enter identical commands for a range
of interface.
Syntax
interface range interface {slot/port[subport] | port} — {slot/
port[subport] | port}, interface {slot/port[/subport] | port} —
{slot/port[/subport] | port},...
Parameters
interface {slot/
port[subport] |
port} — {slot/
port[subport] |
port}, interface
{slot/port[subport]
| port} — {slot/
port[subport] |
port},...
Enter interface range and one of the interfaces and then the
interface information. Select the range of interfaces for bulk
configuration. You can enter up to six comma-separated ranges.
Spaces are not required between the commas. The ranges can
include VLANs, port-channels, and physical interfaces.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a Tunnel interface, enter the keyword Tunnel then a
number from 1 to 16383.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P2) Introduced on the S4038-ON.
9.8(0.0P5) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Interfaces 857