Service Manual

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a tunnel interface, enter the keyword tunnel. The
range is from 1 to 16383.
NOTE: This command also enables you to clear the port
configurations corresponding to a range of ports.
However, for Open Networking (ON) platforms the
notation for specifying port range in the command is
different from how you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as
slot/port-range. For example, if you want to clear the
port configurations corresponding to all ports between 1
and 4, specify the port range as
show interfaces
interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/
port/[subport] - slot/port/[subport]
. For
example, if you want to clear the port configurations
corresponding to all ports between 1 and 4, specify the
port range as show interfaces interface-type
1/1/1 - 1/1/4.
vrrp [ipv6 {vr-id} |
vr-id]
(OPTIONAL) Enter the keyword vrrp to clear the counters of all
VRRP groups. To clear the counters of VRRP groups on all IPv6
interfaces, enter ipv6. To clear the counters of a specified
group, enter a VRID number from 1 to 255.
learning-limit (OPTIONAL) Enter the keywords learning-limit to clear
unknown source address (SA) drop counters when MAC learning
limit is configured on the interface.
vlan vlan-id Enter the keyword vlan followed by the interface VLAN
number. The range is from 1 to 4094.
Defaults Without an interface specified, the command clears all interface counters.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Added support to clear the interface configurations
corresponding to a range of ports.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Interfaces 839