Service Manual

debug ip igmp snooping
Enable debugging of IGMP snooping packets on interfaces and groups.
Syntax
debug ip igmp snooping [group address | interface]
• To disable debugging of IGMP snooping, use the no debug ip igmp snooping
[group address | interface] command.
• To disable all debugging, use the undebug all command.
Parameters
snooping Enter the keyword snooping to enable debugging of IGMP
snooping.
group-address (OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
interface interface Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON,
Z9000, and Z9500.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield
results. This command displays packets for IGMP and IGMP snooping.
Internet Group Management Protocol (IGMP) 827