Service Manual

• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield
results.
The show ip igmp interface command does not display information
corresponding to the loop-back interfaces.
Example
Dell# show ip igmp interface
TenGigabitEthernet 1/1 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 1/5 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 1/6 is down, line protocol is down
Internet protocol processing disabled
TenGigabitEthernet 1/7 is up, line protocol is down
Internet protocol processing disabled
Internet Group Management Protocol (IGMP) 822