Service Manual

show ip igmp groups
View the IGMP groups.
Syntax
show ip igmp [vrf vrf-name] groups [group-address [detail] |
detail | interface [group-address [detail]]]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to configure this setting on that VRF.
group-address (OPTIONAL) Enter the group address in dotted decimal format
to view information on that group only.
interface (OPTIONAL) Enter the interface type and the interface
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
detail (OPTIONAL) Enter the keyword detail to display the IGMPv3
source information.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Internet Group Management Protocol (IGMP) 819