Service Manual

Undo this configuration, that is, remove SSM map (S,G) states and replace them with
(*,G) state, use the ip igmp [vrf vrf-name] ssm-map std-access-list
source-address command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
std-access-list Specify the standard IP access list that contains the mapping
rules for multicast groups.
source-address Specify the multicast source address to which the groups are
mapped.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF and Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.7.1.0 Introduced on the E-Series.
Usage Information Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in
the IGMP groups. You may not use extended access lists with this command. When you
configure a static SSM map and the router cannot find any matching access lists, the
router continues to accept (*,G) groups.
Related
Commands
• ip access-list standard — create a standard access list to filter based on IP address.
Internet Group Management Protocol (IGMP) 817