Service Manual

debug ip igmp
Enable debugging of IGMP packets.
Syntax
debug ip igmp [vrf vrf-name] [group address | interface]
• To disable IGMP debugging, use the no debug ip igmp [vrf vrf-name]
[group address | interface] command.
• To disable all debugging, use the undebug all command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to enable debugging of IGMP packets corresponding to that
VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
group-address (OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
interface interface Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
Internet Group Management Protocol (IGMP) 810