Service Manual

timer
Set the hello interval or dead interval for the Ring control packets.
Syntax
timer {hello-interval milliseconds}| {dead-interval milliseconds}
To remove the timer, use the no timer {hello-interval [milliseconds]}|
{dead-interval milliseconds} command.
Parameters
hello-interval
milliseconds
Enter the keyword hello-interval then the time, in
milliseconds, to set the hello interval of the control packets. The
milliseconds must be entered in increments of 50 millisecond;
for example, 50, 100, 150, and so on. If an invalid value is
entered, an error message is generated. The range is from 50 to
2000 ms. Default: 500 ms.
dead-interval
milliseconds
Enter the keyword dead-interval then the time, in
milliseconds, to set the dead interval of the control packets. The
range is from 50 to 6000 ms. Default: 1500 ms.
NOTE: The configured dead interval must be at least
three times the hello interval.
Defaults
• 500 ms for hello-interval milliseconds
• 1500 ms for dead-intervalmilliseconds
Command Modes CONFIGURATION (conf-frrp)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Force10 Resilient Ring Protocol (FRRP) 774