Service Manual

Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage Information
Use this command to associate the system with one or more DNS servers.
In a dual stack setup, the system sends both A (request for IPv4 — RFC 1035) and AAAA
(request for IPv6 — RFC 3596) record requests to a DNS server even if only the ip
name-server command is configured.
Example
• Dell(conf)#ip name-server vrf jay 2.2.2.2
• Dell(conf)#ip name-server vrf jay 2.2.2.2 3.3.3.3 4.4.4.4
5.5.5.5 6.6.6.6 7.7.7.7
ip domain-name
Configures the default domain corresponding to a specific VRF. This domain is appended to the in complete
DNS requests corresponding to the specified VRF.
Syntax
ip domain-name [vrf vrf-name] name
To undo the domain name configuration corresponding to a specific VRF, use the no
ip domain-name [vrf vrf-name] name command.
Parameters
vrf vrf-name (Optional) Enter the key word vrf and then the name of the VRF
to configure the domain corresponding to that VRF.
name Enter the name of the domain to be appended to the in
complete DNS requests corresponding to the specified VRF.
Defaults None
Dynamic Host Configuration Protocol (DHCP) 719