Service Manual

Table Of Contents

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.0 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

Usage Information This command enables a hardware watchdog mechanism that automatically reboots

an Dell Networking OS switch/ router with a single unresponsive unit. This behavior is a

last-resort mechanism intended to prevent a manual power cycle.

show hardware mac

Display MAC ACL entries for the specified stack-unit, port-pipe and pipeline ID.

Syntax

show hardware mac {eg-acl | in-acl} stack-unit id port-set 0–0

Parameters

eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to

select between ingress or egress ACL data.

stack-unit id Enter the keyword stack-unit to select the stack unit ID.

port-set 0–0 Enter the keywords port-set with a port-pipe number to

display the MAC ACL entries for the specified port-pipe

number. . The range is from 0 to 0.

Defaults None