Service Manual

Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0. Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information When you enable this command, if a Policy Map containing classification rules (ACL
and/or dscp/ ip-precedence rules) is applied to more than one physical interface on the
same port pipe, only a single copy of the policy is written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the
number of interfaces. For more information, refer to the “IP Access Control Lists”,
“Prefix Lists”, and “Route-map” sections in the Dell Networking OS Configuration
Guide.
show cam-acl
Display the details of the CAM profiles on the chassis and all stack units.
Syntax
show cam-acl
Defaults none
Command Modes EXEC Privilege
Content Addressable Memory (CAM) 580