Service Manual

ASN:NNNN Enter the 2-octet AS specific extended community number in
the format ASN:NNNN (2-byte AS number:4-byte community
value).
IPADDR:NN Enter the IP address specific extended community in the format
IPADDR:NN (4-byte IPv4 Unicast Address:2-byte community
value).
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a non-
transitive BGP extended community.
Defaults none
Command Modes ROUTE MAP (config-route-map)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series.
Usage Information
If the set community rt and soo are in the same route-map entry, the behavior defines
as:
• If the rt option comes before soo, with or without the additive option, soo
overrides the communities rt sets.
• If the rt option comes after soo, without the additive option, rt overrides the
communities
soo sets.
• If the rt with the additive option comes after soo, rt adds the communities
soo sets.
Related
Commands
• set extcommunity rt — set the extended community route origins using the route-
map.
Border Gateway Protocol 565