Service Manual

• ^ = (caret) the beginning of the input string. If you use the
caret at the beginning of a sequence or range, it matches
on everything BUT the characters specified.
• $ = (dollar sign) the end of the output string.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp flap command shown in the following
example.
Field Description
Network Displays the network ID to which the route is flapping.
From Displays the IP address of the neighbor advertising the flapping
route.
Flaps Displays the number of times the route flapped.
Duration Displays the hours:minutes:seconds since the route first flapped.
Reuse Displays the hours:minutes:seconds until the flapped route is
available.
Path Lists all the ASs the flapping route passed through to reach the
destination network.
Border Gateway Protocol 538