Service Manual

neighbor send-community
Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all
routes with that attribute belong to the same community grouping.
Syntax
neighbor {ip-address | peer-group-name} send-community [extended |
standard]
To disable sending a COMMUNITY attribute, use the no neighbor {ip-address |
peer-group-name} send-community command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to send a COMMUNITY
attribute to all routers within the peer group.
extended (OPTIONAL) Enter the keyword extended to send extended
community attribute.
standard (OPTIONAL) Enter the keyword standard to send standard
community attribute.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information To configure a COMMUNITY attribute, use the set community command in ROUTE-
MAP mode.
Border Gateway Protocol 503