Service Manual

Related
Commands
• neighbor soft-reconfiguration inbound — assign a subnet to a dynamically
configured BGP neighbor.
• neighbor remote-as — assign an indirectly connected AS to a neighbor or peer
group.
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
Syntax
neighbor {ip-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ip-address | peer-group-
name} remote-as number command.
Parameters
ip-address Enter the IP address of the neighbor to enter the remote AS in its
routing table.
peer-group-name Enter the name of the peer group to enter the remote AS into
routing tables of all routers within the peer group.
number Enter a number of the AS. The range is from 0 to 65535 (2 byte)
or from 1 to 4294967295 (4 byte).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Border Gateway Protocol 498