Service Manual

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
neighbor distribute-list
Distribute BGP information via an established prefix list.
Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-
list-name {in | out}
To delete a neighbor distribution list, use the no neighbor {ip-address | peer-
group-name} distribute-list prefix-list-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the distribute list filter
to all routers in the peer group.
prefix-list-name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to allow
all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
Border Gateway Protocol 486