Service Manual

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series and Z9500.
Related
Commands
• permit bandwidth – specify link band width extended-community attribute as the
matching criteria to permitting incoming or outgoing traffic.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
Syntax
debug ip bgp [ vrf vrf-name | A.B.C.D | X:X:X:X::X | peer-group
peer-group-name] [in | out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to debug
BGP information corresponding to that VRF.
NOTE: Use this attribute to debug BGP protocol
operations corresponding to either a default or non-
default VRF.
A.B.C.D Enter the IPv4 address of the neighbor in dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
Enter the keywords peer-group then the name of the peer
group to debug.
in (OPTIONAL) Enter the keyword in to view only information on
inbound BGP routes.
out (OPTIONAL) Enter the keyword out to view only information on
outbound BGP routes.
A.B.C.D Enter the IP address of peer in the A.B.C.D format.
X:X:X:X::X Enter the IPv6 IP address of peer in the X:X:X:X::X format.
Border Gateway Protocol 467