Service Manual

<1-4294967295> Enter <1-4294967295> to clear peers with the AS number.
<0.1-65535.65535
>
Enter <0.1-65535.65535> to clear peers with the AS number in
dot format.
A.B.C.D Enter the BGP neighbor address in the A.B.C.D format to clear.
X:X:X:X::X Enter the BGP neighbor address in the X:X:X:X::X format to clear.
soft (OPTIONAL) Enter the keyword soft to configure and activate
policies without resetting the BGP TCP session, that is, BGP Soft
Reconfiguration.
NOTE: If you enter the clear ip bgp ip-address
soft command, both inbound and outbound policies
are reset.
in (OPTIONAL) Enter the keyword in to activate only inbound
policies.
out (OPTIONAL) Enter the keyword out to activate only outbound
policies.
NOTE: You must execute the clear ip bgp soft
out command when ever there is a change in the local
policy. If you do not run this command after a local
policy change, then these policy changes are not
reflected in the responses to the peer’s route refresh
messages.
dampening Enter the keyword dampening to clear the flap dampening
information.
flap-statistics Enter the keywords flap-statistics to clear the flap
statistics information.
ipv4 Enter the ipv4 address family to clear.
ipv6 Enter the ipv6 address family to clear.
peer-group Enter the peer-group to clear all members of the peer-group.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
Border Gateway Protocol 461