Service Manual

bgp four-octet-as-support
Enable 4-byte support for the BGP process.
Syntax
bgp four-octet-as-support
To disable fast external failover, use the no bgp four-octet-as-support
command.
Defaults Disabled (supports 2–byte format)
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
Routers supporting 4-byte ASNs advertise that function in the OPEN message. The
behavior of a 4-byte router is slightly different depending on whether it is speaking to a
2-byte router or a 4-byte router.
When creating Confederations, all the routers in the Confederation must be 4 byte or 2
byte identified routers. You cannot mix them.
Where the 2-byte format is from 1 to 65535, the 4-byte format is from 1 to
4294967295. Both formats are accepted and the advertisements reflect the entered
format.
For more information about using the 2 byte or 4-byte format, refer to the Dell
Networking OS Configuration Guide.
Border Gateway Protocol 454