Service Manual

route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name of a
configured route map.
Only match commands in the configured route map are
supported.
Defaults Disabled.
Command Modes
• ROUTER BGP
• ROUTER BGP-address-family
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
If you enter the bgp dampening command, the default values for half-life, reuse,
suppress, and max-suppress-time are applied. The parameters are position-
dependent; therefore, if you configure one parameter, configure the parameters in the
order they appear in the CLI.
Route refresh is sent when you enable BGP dampening.
Related
Commands
• show ip bgp dampened-paths — view the BGP paths.
bgp default local-preference
Change the default local preference value for routes exchanged between internal BGP peers.
Syntax
bgp default local-preference value
Border Gateway Protocol 449