Service Manual

Examples The following sample output shows the line-by-line style display when using the show
running-config acl-vlan-group option. Note that no group or access list names
are truncated
Dell #show running-config acl-vlan-group
!
acl-vlan-group Test
member vlan 1-100
ip access-group test in
Dell#show running-config acl-vlan-group Test
!
acl-vlan-group Test
member vlan 1-100
ip access-group test in
Dell#
acl-vlan-group
Create an ACL VLAN group.
Syntax
acl-vlan-group {group name}
To remove an ACL VLAN group, use the no acl-vlan-group {group name}
command.
Parameters
group-name Specify the name of the ACL VLAN group. The name can contain
a maximum 140 characters.
Default No default behavior or values
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.3.(0.0) Introduced on the S4810, S4820T and Z9000 platforms
Usage Information
You can have up to eight different ACL VLAN groups at any given time. When you
configure an ACL VLAN group, you enter the ACL VLAN Group Configuration mode.
To avoid the problem of excessive consumption of CAM area, you can configure ACL
VLAN groups that combines all the VLANs that are applied with the same ACL in a
single group. A unique identifier for each of ACL attached to the VLAN is used as a
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM) 412