Service Manual

The following table describes the output fields of this show command:
Field Description
Chassis Vlan Cam
ACL
Details about the CAM blocks allocated for ACLs for various
VLAN operations at a system-wide, global level.
Stack Unit
<number>
Details about the CAM blocks allocated for ACLs for various
VLAN operations for a particular stack unit.
Current
Settings(in block
sizes)
Information about the number of FP blocks that are currently in
use or allocated.
VlanOpenFlow Number of FP blocks for VLAN open flow operations.
VlanIscsi Number of FP blocks for VLAN internet small computer system
interface (iSCSI) counters.
VlanHp Number of FP blocks for VLAN high performance processes.
VlanFcoe Number of FP blocks for VLAN Fiber Channel over Ethernet
(FCoE) operations.
VlanAclOpt Number of FP blocks for ACL VLAN optimzation feature.
Example
Dell# show cam-acl-vlan
-- Chassis Vlan Cam ACL --
Current Settings(in block sizes)
VlanOpenFlow : 0
VlanIscsi : 0
VlanAclOpt : 2
VlanHp : 1
VlanFcoe : 1
Dell#
cam-acl-vlan
Allocate the number of flow processor (FP) blocks or entries for VLAN services and processes.
Syntax
cam-acl-vlan { default | vlanopenflow <0-2> | vlaniscsi <0-2> |
vlanaclopt <0-2>
Parameters
default Reset the number of FP blocks to default. By default, 0 groups
are allocated for the ACL in VCAP. ACL VLAN groups or CAM
optimization is not enabled by default, and you need to allocate
the slices for CAM optimization.
vlanopenflow
<0-2>
Allocate the number of FP blocks for VLAN open flow
operations.
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM) 406