Service Manual

seq arp (for Extended MAC ACLs)
Configure an egress filter with a sequence number that filters ARP packets meeting this criteria. This
command is supported only on 12-port GE line cards with SFP optics. For specifications, refer to your line
card documentation.
NOTE: Only the options that have been newly introduced in Release 9.3(0.0) and Release 9.4(0.0) are
described here. For a complete description on all of the keywords and variables that are available with this
command, refer the topic of this command discussed earlier in this guide.
Syntax
seq sequence-number {deny | permit} arp {destination-mac-address
mac-address-mask | any} vlan vlan-id {ip-address | any | opcode
code-number} [count [byte]] [order] [log [interval minutes]
[threshold-in-msgs [count]] [monitor]
To remove this filter, use the no seq sequence-number command.
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering of
ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed
by a value to indicate the maximum number of ACL logs that
can be generated, exceeding which the generation of ACL logs
is terminated. with the seq, permit, or deny commands. You can
enter a threshold in the range of 1-100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time
period in minutes at which ACL logs must be generated. You can
enter an interval in the range of 1-10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL in
which you are creating the rule is applied to the monitored
interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is 5 minutes. By default, flow-
based monitoring is not enabled.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
Access Control Lists (ACL) 380