Service Manual

Related
Commands
• set automatic-tag — compute the tag value of the route.
• set level — specify the OSPF area for route redistribution.
• set metric-type — specify the route type assigned to redistributed routes.
• set tag — specify the tag assigned to redistributed routes.
set metric-type
To assign a new route type for routes redistributed to OSPF, configure a filter.
Syntax
set metric-type {internal | external | type-1 | type-2}
To delete a setting, use the no set metric-type command.
Parameters
internal Enter the keyword internal to assign the Interior Gateway
Protocol metric of the next hop as the route’s BGP
MULTI_EXIT_DES (MED) value.
external Enter the keyword external to assign the IS-IS external metric.
type-1 Enter the keyword type-1 to assign the OSPF Type 1 metric.
type-2 Enter the keyword type-2 to assign the OSPF Type 2 metric.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Implemented the keyword internal.
8.1.1.0 Introduced on the E-Series.
Access Control Lists (ACL) 329