Service Manual

Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related
Commands
• match interface — redistribute routes that match the next-hop interface.
• match ip address — redistribute routes that match an IP address.
• match ip next-hop — redistribute routes that match the next-hop IP address.
• match ip route-source — redistribute routes that match routes advertised by
other routers.
• match metric — redistribute routes that match a specific metric.
• match route-type — redistribute routes that match a route type.
route-map
Enable a route map statement and configure its action and sequence number. This command also places you
in ROUTE-MAP mode.
Syntax
route-map map-name [permit | deny] [sequence-number]
To delete a route map, use the no route-map map-name [permit | deny]
[sequence-number] command.
Access Control Lists (ACL) 319