Service Manual

Monitoring” in the Port Monitoring section in the Dell
Networking OS Configuration Guide.
Defaults Not enabled.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added the monitor option.
Usage Information
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may
become busy as it has to log these packets’ details.
NOTE: When you configure ACL logging and byte counters simultaneously, byte
counters may display an incorrect value. Configure packet counters with logging
instead.
Related
Commands
• permit — configures a MAC address filter to pass packets.
• seq — configures a MAC address filter with a specified sequence number.
mac access-list standard
To configure a standard MAC ACL, name a new or existing MAC access control list (MAC ACL) and enter MAC
ACCESS LIST mode. Also refer to the Commands Common to all ACL Types section and the Common MAC
Access List Commands section.
Syntax
mac access-list standard mac-list-name
Access Control Lists (ACL) 287