Service Manual

Example
Dell(conf)# ip access-list extended TESTListEXTEND
Dell(config-ext-nacl)#
Related
Commands
• ip access-list standard — configure a standard IP access list.
• show config — display the current configuration.
permit
To pass IP packets meeting the filter criteria, configure a filter.
Syntax
permit {source mask | any | host ip-address} {destination mask |
any | host ip-address} [count [bytes]] [dscp value] [order]
[fragments] [no-drop]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence
number.
• Use the no deny {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Parameters
source Enter the IP address in dotted decimal format of the network
from which the packet was sent.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to
the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP
address or hostname.
destination Enter the IP address of the network or host to which the packets
are sent.
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
bytes (OPTIONAL) Enter the keyword bytes to count bytes processed
by the filter.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP
values.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order numbers
have a higher priority). If you do not use the keyword order, the
ACLs have the lowest order by default (255).
Access Control Lists (ACL) 268