Service Manual

Defaults Not configured
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Add the DSCP value for ACL matching.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the
monitor option.
6.5.10 Expanded to include the optional QoS order priority for the
ACL entry.
Usage Information
The order option is relevant in the context of the Policy QoS feature only. The
following applies:
• The seq sequence-number command is applicable only in an ACL group.
• The order option works across ACL groups that are applied on an interface via
the QoS policy framework.
• The order option takes precedence over seq sequence-number.
• If you do not configure sequence-number, the rules with the same order value
are ordered according to their configuration order.
• If you configure sequence-number, the sequence-number is used as a tie
breaker for rules with the same order.
Access Control Lists (ACL) 255