Service Manual

• For a Port Channel interface, enter the keyword port-
channel followed by a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
in | out Identify whether ACL is applied on the ingress or egress side.
vrf vrf-name Enter the keyword vrf and then the name of the VRF to display
the access-lists that are configured on either the default or non-
default VRFs.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.5.1.0 Added support for the 4-port 40G line cards on the E-Series.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Standard IP ACL Commands
When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an
implicit permit.
The platform supports both Ingress and Egress IP ACLs.
NOTE
: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections.
deny
To drop packets with a certain IP address, configure a filter.
Syntax
deny {source | any | host {ip-address}} [no-drop]
Access Control Lists (ACL) 247