Service Manual

Version Description
7.4.1.0 Introduced on the E-Series.
mac
Configure a list of supplicant MAC addresses for dot1x profile represented with a profile-name.
Syntax
[no] mac {mac-address1 mac-address2… mac-address6}
Parameters
mac-address1
mac-address2…
mac-address6
Enter the keyword mac and type the 48– bit MAC addresses
using the H.H.H format. A maximum of 6 MAC addresses are
allowed.
Defaults None
Command Modes
DOT1X PROFILE CONFIG (conf-dot1x-profile)
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810,
S4820T, S5000, S6000, S6000–ON, the Configuration Terminal
Batch mode on C9010, Z9100–ON, and Z9500.
9.9(0.0) Introduced on the C9010.
Usage Information
The mac command configures a list of supplicant MAC addresses for a dot1x profile
represented with a profile-name. You can configure up to 6 MAC addresses in a single
mac command. The maximum number of MAC addresses that you can configure in a
single profile is limited to 100.
Use this command in Configuration Terminal Batch mode to configure a list of
supplicant MAC addresses for dot1x profile in a dual-homing setup.
Example
Dell(conf)#dot1x profile mySupplicants
Dell(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:01:11
Dell(conf-dot1x-profile)#show config
dot1x profile mySupplicants
mac 00:50:56:aa:01:10
802.1X 229