Service Manual

dot1x static-mab
Enable static MAC authorization bypass (MAB) and configure static MAB profile to an interface.
Syntax
[no] dot1x static-mab profile profile-name
Parameters
profile profile-
name
Enter the keyword profile and the profile-name to configure
the static MAB profile name. The profile name length is limited
to 32 characters.
Defaults Disabled.
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the S3100 series, S4048–ON, S4048–ON, S4810,
S4820T, S5000, S6000, S6000–ON, the Configuration Terminal
Batch mode on C9010, Z9100–ON, and Z9500.
9.9(0.0) Introduced on the C9010.
Usage Information
The dot1x static-mab command enables static MAB (mac auth bypass) and
configures the associated profile on a dot1x interface. Static MAB bypasses the
authentication server for the supplicant MAC addresses configured in the associated
profile.
Before you enable static MAB, you must do the following:
• Enable MAC authentication bypass on the port by configuring the dot1x mac-
auth-bypass command.
• Ensure that no configured profile exists at the time of configuring the static-
mab command.
• Use this command in Interface Batch Mode to enable static MAB in a dual-homing
setup.
Example
Dell(conf)#do show dot1x interface ten gigabit ethernet 0/41
802.1x information on Te 0/41:
----------------------------------------
Dot1x Status: Enable
802.1X 226