Service Manual

Interface Group Pri Pre State Master addr Virtual addr(s)
Description
--------------------------------------------------------------------
Fo 1/50 IPv4 20 100 Y Master 10.0.0.3 10.0.0.2
Dell#
track
Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled.
Syntax
track interface [priority-cost cost]
To disable monitoring, use the no track interface command.
Parameters
interface (OPTIONAL) Enter the following keywords and the interface
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan, and then
the VLAN ID. The VLAN ID range is from 1 to 4094.
priority-cost (OPTIONAL) Enter a number as the amount to subtract from the
priority value. The range is from 1 to 254. The default is 10.
Defaults priority cost = 10
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Virtual Router Redundancy Protocol (VRRP) 2092