Service Manual

• show vlt counters
• show vlt detail
• show vlt inconsistency
• show vlt mismatch
• show vlt role
• show vlt statistics
• show vlt statistics igmp-snoop
• system-mac
• unit-id
• vlt domain
• vlt-peer-lag port-channel
• show vlt private-vlan
back-up destination
Configure the IPv4 or IPv6 address of the management interface on the remote VLT peer used as the VLT
backup link endpoint for sending out-of-band (OOB) hello messages.
Syntax
back-up destination {[ipv4–address] | [ipv6 ipv6–address]
[interval seconds]}
Parameters
ipv4–address Enter the IPv4 address of the backup destination.
ipv6 Enter the keyword ipv6 then an IPv6 address in the X:X:X:X::X
format.
interval seconds Enter the keyword interval to specify the time interval to send
hello messages. The range is from 1 to 5 seconds. The default is
1 second.
Defaults 1 second
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
Virtual Link Trunking (VLT) 2036