Service Manual

vlan-stack dot1p-mapping
Map C-Tag dot1p values to an S-Tag dot1p value.
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
Parameters
c-tag-dot1p value Enter the keyword c-tag-dot1p then the customer dot1p value
that is mapped to a service provider do1p value. The range is
from 0 to 7.
sp-tag-dot1p
value
Enter the keyword sp-tag-dot1p then the service provider
dot1p value. The range is from 0 to 7.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the C-Series and S-Series.
Usage Information
You can separate the C-Tag values by commas or dashed ranges. In the case of
conflicts, dynamic mode CoS overrides any Layer 2 QoS configuration.
VLAN Stacking 2007