Service Manual

Command Modes INTERFACE TUNNEL
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added the decapsulate-any command.
9.3(0.1) Introduced on the S6000 and Z9000.
Usage Information
To enable a tunnel interface, use this command. You must define a tunnel mode for the
tunnel to function. If you previously defined the tunnel destination or source address,
the tunnel mode must be compatible.
Including the decapsulate-any option causes the command to fail if any of the
following tunnel transmit options are configured: tunnel destination, tunnel dscp,
tunnel flow-label, tunnel hop-limit, or tunnel keepalive. Conversely, if you configure
any tunnel allow-remote entries, the tunnel—mode command fails unless the
decapsulate-any option is included.
Configuration of IPv6 commands over decapsulate-any tunnel causes an error.
tunnel source
Set a source address for the tunnel.
Syntax
tunnel source {ip-address | ipv6–address | interface-type-number |
anylocal}
To delete the current tunnel source address, use the no tunnel source command.
Parameters
ip-address Enter the source IPv4 address in A.B.C.D format.
ipv6–address Enter the source IPv6 address in X:X:X:X::X format.
interface-type-
number
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
Tunneling 1984