Service Manual

ipv6–address Enter the destination IPv6 address for the tunnel.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.3(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
Usage Information
The tunnel interface is inoperable without a valid tunnel destination address for the
configured Tunnel mode.
To establish a logical tunnel to the particular destination address, use the destination
address of the outer tunnel header. If you configure a tunnel interface or source
address, the tunnel destination must be compatible.
tunnel dscp
Configure the method to set the DSCP in the outer tunnel header.
C9000 Series
Syntax
tunnel dscp {mapped | value}
To use the default tunnel mapping behavior, use the no tunnel dscp value
command.
Parameters
mapped Enter the keyword mapped to map the original packet DSCP
(IPv4)/Traffic Class (IPv6) to the tunnel header DSCP (IPv4)/
Traffic Class (IPv6) depending on the mode of tunnel.
Tunneling 1979