Service Manual

mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D to match a range of remote addresses. The default mask
is /32 for IPv4 addresses and /128 for IPv6 addresses, which
match only the specified address.
Defaults If you do not configure tunnel allow remote , all traffic which is destined to tunnel
source address is decapsulated.
Command Modes INTERFACE TUNNEL
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
9.3(0.1) Introduced on the S6000 and Z9000.
Usage Information
You can configure up to eight allow-remote entries on any multipoint receive-only
tunnel.
This command fails if the address family entered does not match the outer header
address family of the tunnel mode, tunnel source, or any other tunnel allow-remote.
If you configure any allow-remote , the tunnel source or tunnel mode commands fail if
the outer header address family does not match that of the configured allow-remote.
tunnel destination
Set a destination endpoint for the tunnel.
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-
address | ipv6–address} command.
Parameters
ip-address Enter the destination IPv4 address for the tunnel.
Tunneling 1978