Service Manual

Version Description
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON,
S5000, S6000, S6000–ON, Z9500, MXL.
Usage Information This command is optional for SupportAssist service configuration.
SupportAssist Server Commands
Dell Networking OS supports the following SupportAssist Server mode commands.
proxy-ip-address
Configure a proxy for reaching the SupportAssist remote server.
Syntax
proxy-ip-address {ipv4-address | ipv6-address} port port-number
[ username userid password [encryption-type] password ]
To remove the proxy, use the no proxy-ip-address command.
Parameters
ipv4-address Enter the IP address of the proxy server in a dotted decimal
format (A.B.C.D).
ipv6-address Enter the IPv6 address of the proxy server in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
NOTE: To use the IPv6 address, the Open Automation
package should also support IPv6 communications. For
this purpose, SupportAssist requires Dell Networking
Open Automation 9.10(0.0) package or later.
port port-number Enter the keyword port then the TCP/IP port number. The port
number range is from 80 to 100000.
username userid (OPTIONAL) Enter the keyword username then the user ID used
for the proxy server.
password Enter the keyword password then the encryption-type or the
user password.
encryption-type (OPTIONAL) Enter an encryption type for the password you
enter.
• 0 directs the system to interpret the password as clear text.
SupportAssist 1947