Service Manual

Parameters
ipv4-address Enter the IP address of the active management interface in a
dotted decimal format (A.B.C.D.).
ipv6-address Enter an IPv6 address of the active management interface, in the
x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only one of
each. Each time this command is issued, it replaces the previously configured address
of the same family, IPv4 or IPv6. The no virtual-ip command takes an address/
prefix-length argument, so that the desired address only is removed. If you enter the no
virtual-ip
command without any specified address, then both IPv4 and IPv6 virtual
addresses are removed.
Related
Commands
• ip address — assigns a primary and secondary IP address to the interface.
Control and Monitoring 185