Service Manual

Version Description
E-Series legacy
command
snmp-server trap-source
Configure a specific interface as the source for SNMP traffic.
Syntax
snmp-server trap-source interface
To disable sending traps out a specific interface, use the no snmp trap-source
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a Null interface, enter the keyword null then the Null
interface number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults The IP address assigned to the management interface is the default.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
Simple Network Management Protocol (SNMP) and Syslog 1845