Service Manual

is a port connected to Router2. This is a port connected to
Router2. This is a
port connected to Router2. This is a port connected to Router2.
IF-MIB::ifAlias.134792448 = STRING:
Dell#config
snmp-server community
Configure a new community string access for SNMPv1 v2 and v3.
Syntax
snmp-server community community-name {ro | rw} [ipv6 ipv6-access-
list-name [ipv6 ipv6-access-list-name | access-list-name |
security-name name] | security-name name [ipv6 ipv6-access-list-
name | access-list-name | security-name name] | access-list-name
[ipv6 ipv6-access-list-name | access-list-name | security-name
name]]]
To remove access to a community, use the no snmp-server community
community-string {ro | rw} [security-name name [access-list-name |
ipv6 access-list-name | access-list-name ipv6 access-list-name]]
command.
Parameters
community-name Enter a text string (up to 20 characters long) to act as a
password for SNMP.
ro Enter the keyword ro to specify read-only permission.
rw Enter the keyword rw to specify read-write permission.
ipv6 access-list-
name
(Optional) Enter the keyword ipv6 then an IPv6 ACL name (a
string up to 16 characters long).
security-name
name
(Optional) Enter the keywords security-name then the
security name as defined by the community MIB.
access-list-name (Optional) Enter a standard IPv4 access list name (a string up to
16 characters long).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Simple Network Management Protocol (SNMP) and Syslog 1831