Service Manual

NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults
• Timeout = 5 seconds
• Probe count = 3
• 30 hops max
• 40 byte packet size
• UDP port = 33434
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series with IPv6.
8.1.1.0 Introduced on the E-Series (IPv4 only).
7.9.1.0 Introduced VRF.
7.6.1.0 Added support for the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for IPv6 address on the E-Series.
E-Series Original command.
Usage Information When you enter the traceroute command without specifying an IP address
(Extended Traceroute), you are prompted for a target and source IP address, timeout (in
seconds) (default is 5), a probe count (default is 3), minimum TTL (default is 1),
Control and Monitoring 182